Toyota 1KZ-TE Repair Manual page 307

CLICK HERE TO VIEW CHAPTER INDEX
6 mm Drill
4 mm Drill
STARTING - - PRE- -HEATING SYSTEM
(2) Insert the taped 54 mm (2.13 in.) of the drill into the
plug hole and turn the drill by hand to remove the
carbon.
(3) Insert a 4 mm drill into the glow plug hole and turn
the drill by hand to remove the carbon from the tip
of the plug hole.
Z09485
(4) Using a 12 mm deep socket wrench, install the 4
glow plugs to the cylinder head.
Torque: 13 N∙m (130 kgf∙cm, 10 ft∙lbf)
(5) Install the glow plug wire to the glow plug.
(6) Install the glow plug connector to the glow plugs
with the 4 nuts.
P13094
(7) Install the 4 screw grommets to the glow plugs.
(d) Install the intake pipe.
P13105
1KZ-TE Pages From Manual
TO MODEL INDEX
(See page EM -- 64)
ST- -5