Toyota 1KZ-TE Repair Manual page 212

CLICK HERE TO VIEW CHAPTER INDEX
TC- -14
Stroke
TURBOCHARGING - -
(d) Remove the SST.
4 . ADJ US T ACTUATO R P US H RO D S T RO KE
NOTICE:
Never apply more than 141 kPa (1.44 kgf/cm
pressure to the actuator.
SST
(a) Using a dial indicator, set the dial indicator in a straight line
with the actuator push rod.
(b) Using SST, apply 119 kPa (1.21 kgf/cm
sure to the actuator, and measure the actuator push rod
stroke.
S04400
SST
(c) From the table below select the plate washer thickness to
match the stroke measured in (b) above.
Stroke measurement
1.20 - - 1.70 (0.0472 - - 0.0669)
1.71 - - 2.20 (0.0673 - - 0.0866)
2.21 - - 2.70 (0.0870 - - 0.1063)
2.71 - - 3.20 (0.1067 - - 0.1260)
3.21 - - 3.70 (0.1264 - - 0.1457)
3.71 - - 4.20 (0.1461 - - 0.1654)
4.21 - - 4.70 (0.1657 - - 0.1850)
4.71 - - 5.20 (0.1854 - - 0.2047)
5.21 - - 5.70 (0.2051 - - 0.2244)
5.71 - - 6.20 (0.2248 - - 0.2441)
6.21 - - 6.70 (0.2445 - - 0.2638)
6.71 - - 7.20 (0.2642 - - 0.2827)
7.21 - - 7.70 (0.2839 - - 0.3031)
7.71 - - 8.20 (0.3035 - - 0.3228)
NOTICE:
Use a combination of plate washers of 0.5 mm (0.020
S S S S
in.), 1.0 mm (0.039 in.), 2.0 mm (0.079 in.) and 3.0 mm
(0.118 in.) thickness to achieve the required thick-
ness.
Use the same thickness of plate washer for the 2 loca-
S S S S
tions between the actuator and compressor housing.
If the plate washer thickness exceeds 3.5 mm (0.138
S S S S
in.), replace the actuator installation bolts with the
bolts from the kit part.
TURBOCHARGER
09992 -- 00242
mm (in.)
1KZ-TE Pages From Manual
TO MODEL INDEX
2
, 20.5 psi) of
2
, 17.2 psi) of pres-
Required plate washer thickness
mm (in.)
None required
0.5 (0.020)
1.0 (0.039)
1.5 (0.059)
2.0 (0.079)
2.5 (0.098)
3.0 (0.118)
3.5 (0.138)
4.0 (0.157)
4.5 (0.177)
5.0 (0.197)
5.5 (0.217)
6.0 (0.236)
6.5 (0.256)
CONTINUED