Toyota 1KZ-TE Repair Manual page 211

CLICK HERE TO VIEW CHAPTER INDEX
New V--Band
Snap Ring
New
E--Ring
TURBOCHARGING
(g)
Matchmarks
B09287
(h)
(i)
3
4
(j)
5
6
(k)
60˚
2
1
60˚
B09309
2.
Knock Pin
(a)
NOTICE:
Notch
B09310
(b)
B09285
3 .
Actuator
SST
(a)
NOTICE:
Never apply more than 141 kPa (1.44 kgf/cm
pressure to the actuator.
(b)
(c)
S04398
- - TURBOCHARGER
Align the matchmarks on the V--band, turbine housing
and bearing housing, and temporarily tighten with a new
bolt and nut.
Torque: 4.8 N∙m (49 kgf∙cm, 42 in.∙lbf)
Using a brass bar and hammer, hit 2 or 3 times lightly at
each place in order of 1 through 5.
Tighten the bolt and nut more.
Torque: 4.8 N∙m (49 kgf∙cm, 42 in.∙lbf)
Using a brass bar and hammer, hit 2 or 3 times lightly at
each place of 1 and 4.
Tighten the bolt and nut completely.
INSTALL COMPRESSOR HOUSING
Align the knock pin of the bearing housing with the notch
of the compressor housing, and install them.
Do not make the impeller wheel interfere with the
S S S S
compressor housing.
Check that the turbine shaft truns smoothly.
S S S S
Using snap ring pliers, install the snap ring to the com-
pressor housing.
I NS TALL ACTUATO R
Using SST, apply pressure to the actuator.
SST 09992 -- 00242
Connect the actuator push rod to the waste gate valve link
with a new E--ring.
Install the actuator with the 2 bolts.
Torque: 19.1 N∙m (195 kgf∙cm, 14 ft∙lbf)
1KZ-TE Pages From Manual
TO MODEL INDEX
TC- -13
2
, 20.5 psi) of
CONTINUED