Toyota 1KZ-TE Repair Manual page 164

CLICK HERE TO VIEW CHAPTER INDEX
(h)
(i)
ENGINE MECHANICAL
2 4 .
(a)
(b)
(c)
(d)
(e)
(f)
(g)
P11700
(h)
(i)
(j)
(k)
(j)
2 5 .
S04839
2 6 .
27.
- - CYLINDER HEAD
I NS TALL I NTAKE P I P E
Install the VSV for the No.1 and No.2. intake constrictor
control. (See page ED -- 13)
Install the accelrator cable bracket to the intake pipe.
Torque: 20 N∙m (204 kgf∙cm cm, 15 ft∙lbf)
Place a new gasket on the venturi.
Connect the intake pipe and PCV hose.
Place the clamp lock together with the pliers and press
down the tip of the lock plate. Carefully let the lock spread
apart. Take care not to let the pliers slip.
Install the 4 seal washers and nuts.
Torque: 12 N∙m (120 kgf∙cm, 9 ft∙lbf)
install the vacuum hose clamp with the bolt to the cylinder
head.
Connect the vacuum hose to the actuator of the chamber
A.
Connect the vacuum hose to the actuator of the chamber
B.
Connect the vacuum hose to the 3--way (from the vacuum
pump).
Connect the VSV for the No.1 and No.2 intake constrictor
control connectors.
FI LL WI TH E NG I NE CO O LANT
S TART E NG I NE AND CHE CK FO R L E AKS
RECHECK ENGINE COOLANT LEVEL AND OIL LEV -
EL
1KZ-TE Pages From Manual
TO MODEL INDEX
EM- -71