Toyota 1KZ-TE Repair Manual page 158

CLICK HERE TO VIEW CHAPTER INDEX
Hole Number
Front
"2"
"4"
ENGINE MECHANICAL - -
(b) Select a new cylinder head gasket.
HINT:
There are 5 types of cylinder head gasket (hole number 1 to 5)
installed at factory, but only 3 types for supply parts (hole num-
ber "1", "3" and "5"), so when replacing the gasket select from
one of 3 types above.
Installed cylinder head gasket thickness:
Hole number "1"
Hole number "3"
"1"
Hole number "5"
Select the largest piston protrusion value from the mea-
surements made, then select the appropriate cylinder
"3"
head gasket according to the table below.
"5"
P11930
2 . S E T NO . 4 CY LI NDE R TO T DC / CO MP RE S S I O N
TDC
Turn the crankshaft pulley, and align the TDC mark of the timing
Mark
gear cover with the No.2 camshaft timing pulley.
S04988
3 . P L ACE CY LI NDE R HE AD O N CY L I NDE R BLO CK
(a) Place a new cylinder head gasket in position on the cylin-
der block.
NOTICE:
Be careful of the installation direction.
(b) Place the cylinder head in position on the cylinder head
gasket.
S04987
CYLINDER HEAD
0.80 - - 0.90 mm (0.0315 - - 0.0354 in.)
0.90 - - 1.00 mm (0.0354 - - 0.0394 in.)
1.00 - - 1.10 mm (0.0394 - - 0.0433 in.)
Piston protrusion mm (in.)
0.08 - - 0.12 (0.0031 - - 0.0047)
0.13 - - 0.22 (0.0051 - - 0.0087)
0.23 - - 0.33 (0.0091 - - 0.0130)
1KZ-TE Pages From Manual
TO MODEL INDEX
EM- -65
Gasket size
Use "1"
Use "3"
Use "5"
CONTINUED