Honda TRX450R Service Manual page 464

BATTERY/CHARGING SYSTEM (After '05)
STATOR REPLACEMENT
Remove the left crankcase cover (page 21-11).
Remove the four bolts, wire clamp and ignition
pulse generator.
Remove the three socket bolts, wire grommet and
alternator stator from the left crankcase cover.
Install the alternator stator into the left crankcase
cover and tighten the three socket bolts to the spec-
ified torque.
TORQUE: 9.8 N m (1.0 kgf-m, 7 Ibfft)
Install the wire grommet into the left crankcase
cover groove properly.
Install the ignition pulse generator and wire clamp
and tighten the four bolts to the specified torque.
TORQUE: 5 N m (0.5 kgf-m, 3.6 Ibfft)
Install the left crankcase cover (page 21-13).
FLYWHEEL REMOVAL
Remove the left crankcase cover (page 21-11).
Hold the flywheel using the special tool and loosen
the flywheel nut.
TOOL:
Flywheel holder 07725-0040000 or
equivalent
commercially
available
Remove the flywheel nut and washer.
Remove the flywheel using the special tool.
TOOL:
Flywheel puller 070MC-HP10100or
070MC-HP1A100
(U.S.A. only)
GROMMET
STATOR
IGNITION PULSE
GENERATOR
CLAMP
Remove the woodruff key from the crankshaft.
FLYWHEEL INSTALLATION
Clean any oil from the tapered portion of the crank-
shaft and flywheel.
Install the woodruff key into the crankshaft key
groove.
21-12