FRONT WHEEL/SUSPENSION/STEERING
Press the spherical bearing out of the arm using the
. . . [ , . . . „ P>DIWCD
special tool.
07HMF-HC00100
TOOL:
Spherical bearing driver
Install a new stopper ring into the arm pivot groove
properly.
Press a new bearing into the arm pivot until it con-
tacts the stopper ring, using the same tool.
Install a new stopper ring into the opposite side
groove.
Pack 3 g (0.1 oz) of grease into the arm pivot as
shown.
Apply grease to new dust seal lips and install them
into the arm pivot until they are flush with the pivot
ends.
INSTALLATION
Install the pivot collars into the arm pivots.
Install the lower arm into the frame, insert the pivot
bolts from the front side and tighten the pivot nuts.
TORQUE: 39 N m (4.0 kgf m, 29 Ibfft)
Install the shock absorber lower mount into the
lower arm, insert the bolt from the front side and
tighten the pivot nut.
TORQUE: 39 N-m (4.0 kgf m, 29 Ibfft)
Install the upper arm into the frame, insert the pivot
bolts from the front side and tighten the pivot nuts.
TORQUE: 39 N-m (4.0 kgf m, 29 Ibfft)
:DUST SEALS
PIVOT COLLARS
SHOCK ABSORBER
LOWER ARM
UPPER ARM
17-22