Honda TRX450R Service Manual page 391

REAR WHEEL/SUSPENSION
The lock nuts have
left hand threads.
Refer to page 18-3
for torque wrench
reading information.
Coat a new O-ring with oil and install it into the
brake disc flange groove.
Install the brake disc onto the flange with new bolts
if it was removed.
TORQUE: 42 N m (4.3 kgf-m, 31 Ibf-ft)
Apply grease to the rear axle splines.
Install the brake disc flange onto the rear axle.
Install the skid plate (page 3-8).
Apply molybdenum disulfide grease to the clip con-
tacting area of the outer lock nut on the rear axle
bolt.
Install the rear axle bolt with the inner and outer
lock nuts.
Install the stopper ring but do not install it into the
ring groove yet.
BRAKE DISC FLANGE
REAR AXLE BOLT
Turn the outer lock nut clockwise until the stopper
ring groove is covered with the outer lock nut and
apply locking agent to the axle bolt threads.
Turn the outer lock nut counterclockwise until the
ring groove is visible and install the stopper ring
into the groove.
Turn the outer lock nut clockwise to seat it against
the stopper ring.
Tighten the outer lock nut using the special tool.
TOOL:
Lock nut wrench, 45.5 mm 07916-1870101 or
commercially
available
equivalent
TORQUE: Actual: 88 N m (9.0 kgf m, 65 Ibf-ft)
Indicated: 79 N m (8.1 kgf m, 59 Ibf-ft)
STOPPER RING
OUTER LOCK NUT
18-15