FRONT WHEEL/SUSPENSION/STEERING
Install the brake hose clamps with new bolts and
tighten the bolts.
TORQUE: 12 N-m (1.2 kgf-m, 9 Ibf-ft)
Install the carry pipe and tighten the four bolts
securely.
Install the knuckle onto the upper and lower arms
with the washers and castle nuts.
Tighten the nuts to the specified torque and further
tighten them until the grooves align with the cotter
pin holes.
TORQUE: 32 N-m (3.3 kgf-m, 24 Ibf-ft)
Install new cotter pins.
Install the tie-rod onto the knuckle.
Install and tighten the ball joint nut while holding
the joint stud flat surfaces with an open end wrench.
TORQUE: 44 N m (4.5 kgf-m, 33 Ibf-ft)
Install new cotter pin.
Install the wheel hub (page 17-17).
Adjust the toe (page 4-33).
17-23