Honda TRX450R Service Manual page 344

CRANKCASE/TRANSMISSION/CRANKSHAFT/BALANCER (After '05)
Install the dowel pins and a new gasket onto the left
crankcase.
Coat the oil seal contacting surface of the crankshaft
with oil.
DOWEL PINS
Install the right crankcase onto the left crankcase.
GASKET
RIGHT CRANKCASE
Apply locking agent to the crankcase bolt threads.
Install the crankcase bolts and washers.
Tighten the bolts in a crisscross pattern in 2 or 3
steps.
Apply oil to the drain bolt threads and seating sur-
face.
Install a new washer and tighten the drain bolt to
the specified torque.
TORQUE: 22 N m (2.2 kgf m, 16 Ibfft)
Carefully trim the protruding gasket material from
the cylinder gasket surface.
NOTICE
• Do not let the gasket material fall into the crank-
case.
• Do not damage the cylinder gasket surface.
TRX450ER: Install a new washer and tighten the neutral switch
to the specified torque.
TORQUE: 12 N m (1.2 kgf m, 9 Ibfft)
TRX450R. Install a new washer and tighten the neutral switch
hole plug bolt to the specified torque.
TORQUE: 12 N-m (1.2 kgf m, 9 Ibfft)
'iLUU I
BOLT/WASHER
NEUTRAL SWITCH/WASHER
(HOLE PLUG BOLT)
BOLTS/WASHERS H DRAIN BOLT/WASHER
WASHER SET POSITON
APPLY LOCKING AGENT
16-26