Honda TRX450R Service Manual page 365

FRONT WHEEL/SUSPENSION/STEERING
Once the tool is in place, turn the adjusting bolt as
necessary to make the jaws parallel.
Then hand-tighten the pressure bolt and recheckthe
jaws to make sure they are still parallel.
Tighten the pressure bolt with a wrench until the
ball joint stud pops loose.
Remove the ball joint nuts, washers and knuckle
from the upper and lower arms.
ADJUSTING BOLT PRESSURE BOLT
Remove the following:
- four bolts and carry pipe
- bolts and brake hose clamps
pivot nuts, bolt and upper arm
shock absorber lower mounting nut and bolt
pivot nuts, bolt and lower arm
LOWER ARM
17-20