Honda TRX450R Service Manual page 389

REAR WHEEL/SUSPENSION
Clean the bearing holder outer surface and the
swingarm inner surface.
Coat new O-rings with oil and install them into the
bearing holder grooves.
Apply grease to the bearing holder outer surface.
Be careful not to Install the bearing holder into the swingarm until it
damage the is fully seated.
Install a new seal rubber into the swingarm.
Apply molybdenum disulfide grease to the bearing
holder pinch bolts and loosely install the pinch
bolts.
Coat new O-rings with oil and install them into the
caliper stay groove and onto the bearing holder.
Install the bushing onto the stopper bolt.
Apply grease to the inner surface of the caliper stay
and install it onto the bearing holder and bushing.
SEAL RUBBER
BUSHING
STAY
18-13