FRONT WHEEL/SUSPENSION/STEERING
Install the steering shaft collar.
Install the steering shaft end nut and tighten it.
TORQUE: 69 N m (7.0 kgf m, 51 Ibfft)
Install a new cotter pin.
Install the tie-rods onto the steering shaft.
Install the ball joint nuts and tighten them while
holding the ball joint stud flats with an open end
wrench.
TORQUE: 44 N m (4.5 kgf-m, 33 Ibfft)
Install new cotter pins.
Do not twist or Install the handlebar assembly onto the steering
bend the brake shaft with the washers and lower holder nuts.
hose and pipe. Tighten the nuts.
TORQUE: 39 N m (4.0 kgf-m, 29 Ibfft)
COTTER PIN
I
TIE-RODS ^ ^ ^ ^ H NUTS
17-29