FUEL SYSTEM ('04 - '05)
Check the hot start valve face for scores, scratches
or wear.
Check the seal ring for deterioration, wear or dam-
age.
Replace the hot start valve set if necessary.
Install the hot start valve into the carburetor and
tighten the valve nut.
TORQUE: 3 N m (0.3 kgf-m, 2.2 Ibfft)
Install the rubber cap onto the hot start valve nut
properly.
HOT START VALVE NUT
Connect the carburetor heater 2P and throttle posi-
tion sensor 3P connectors, and clamp their wires
properly.
< \ 1
CLAMP r
i
V
CONNECTORS
Connect the drain hose to the carburetor.
Install the fuel tank (page 3-9).
7-22