Configuration Of Job Template - Xerox ApeosPort C6550 I Network Administrator's Manual

11 Using Scan Service

Configuration of Job Template

Preparations
Installation Overview
11
Enabling Port and Setting TCP/IP
1
2
98
The below environment is required to use the job template scan feature on the
machine.
‑CentreWare Scan Service
This section describes the configuration procedure to use the job template scan
function on the machine.
The following is the procedure to use the job template scanning.
Enabling Port and Setting TCP/IP
Enable the SNMP port, Internet Service (HTTP) port, and FTP client port, and set an
IP addresses on the machine.
Configuring the SNMP port
Configure the transport protocol for the SNMP port using CentreWare Internet
Services.
In order to use CentreWare scan service on the machine, enable the port and set the
IP address. The procedure for setting the machine is as follows.
Note • The configuration can also be performed using CentreWare Internet Services.
For information how to use CentreWare Internet Services, refer to "Using CentreWare Internet
Services" (P.53).
Display the [System Administrator Menu] screen.
1) Press the <Log In/Out> button.
2) Enter the UserID with the numeric keypad or a keyboard displayed by pressing
[Keyboard], and select [Confirm].
Note • The default UserID is "11111". When using the Authentication feature, a password is
required. The default password is "x-admin".
3) Select [System Settings].
Enable the SNMP port.
1) Select [System Settings].
2) Select [Network Settings].
3) Select [Port Settings].
4) Select [SNMP] and then select [Change Settings].
5) Select [Port Status] and select [Change Settings].
6) Select [Enabled] then select [Save].
7) Select [Exit].
8) Enable the FTP client port and the Internet service (HTTP) port as above.
9) Select [Close] repeatedly until the [Network Settings] screen is displayed.