Scanning The Targets; Scanning The Targets With The Document Feeder (Dadf); Scanning The Targets With The Platen Glass - Xerox Versant 80 Press System Administration Manual

Simple Image Quality Adjustment (SIQA)

Scanning the Targets

After collecting the printed targets from the press output area, you must review them
and choose which scanning option is the best to use for scanning the targets: the
Document Feeder or the Document Glass
Document Glass: Select this option if the targeted media is larger than 11 x 17 in.
(A3) or heavier than 220 gsm.
Document Feeder: This option provides a faster and easier scan process; however,
the Document Glass is more accurate. The accuracy of the Document Feeder is within
0.2 mm, while the accuracy of the Platen Glass is within 0.1 mm.
Related Topics:

Scanning the Targets with the Document Feeder (DADF)

Scanning the Targets with the Platen Glass

Scanning the Targets with the Document Feeder (DADF)
1. Place all of the target sheets in the Document Feeder. The orientation of a target
sheet is not important when using the DADF.
2. Select the Scan Chart with Document Feeder button on the UI.
3. Select Scan.
4. After the scanning completes, select Start.
5. To continue, go to Saving the
Related Topics:
Scanning the Targets
Scanning the Targets with the Platen Glass
1. Select the Scan Chart with Document Glass button on the UI.
In the next steps, you will scan the Calibration Chart 4 times; 2 times per side. For
each scan you will reposition the chart.
For each scan do not place the target against the registration edge, but leave at least
20 mm to the edge of the glass. Also makesure the target is not skewed more than
15 degrees:
5-4
Profile.
Xerox ® Versant ® 80 Press
System Administration Guide