Access Code; Night Mgr - Delphi Display Systems RDS-INSFTTCU Configuration And User's Manual

Delphi Display Systems, Inc. RDS-INSFTTCU Page 28 of 82

4.7.2 Access Code

®
This lets you secure your Fast Track Timer from unauthorized access.
You may assign up to four Access Codes, identified as A, B, C, and D.
An unused access code is displayed as "UNUSED" and a used access
code is displayed as "SET". When no access code has been set, the
default code is "000000". Once any of the access codes has been set,
however, the default access code "000000" no longer allows access.
Note: If any or all of the access codes has been changed, you must
change the access code in Site (See –
Section 4.2 Site) to match any
access code A – D with the new change. Otherwise, you will receive an
®
"invalid access code" when you try to connect to the Fast Track
Timer.

4.7.3 Night Mgr

Night Manager allows you to set up a time period to track particular
events over a period of time, as well as identify problems and their
causes (which is particularly useful for absentee management), to view
®
or print at the Fast Track Timer(printing applies only to 2000 series
timers).
®
The Fast Track Timer only uses these times in fifteen minute
increments and uses AM and PM. When setting the time for store hours
the software will compensate for times such as 6:22 and will
automatically set that value to 06:15 AM. The program will always move
back to the closest fifteen-minute interval. You can use either an A or a
P to designate AM or PM. An example would be 6:00p or 18:00 will both
give you 06:00PM. If you set the time for 12:00 this will give you
12:00PM and 00:00 will give you 12:00AM.
Confidential Document:
Do not copy or distribute without written permission from Delphi Display Systems, Inc.
Copyright 2012. [Unpublished Work]. All rights reserved