Layout; Button Functions - Kemppi FastMig MXP 37 Pipe Steel Operating Manual

3.2

Layout

10.
CH REMOTE
CHANNEL
5. 6.
1. Main switch (long press)
2. Activates MIG welding dynamics (short press)
Selects the active wire feeder, if several wire feeders exist (long press)
3. Gas test
4. Wire inch
5. Selects the previous memory channel
6. Selects the next memory channel (short press)
Locks selected memory channel (long press)
7. Selects welding gun trigger mode (short press) or turns MatchLog function ON/OFF
8. Selects crater fill, hot start (short press) or MMA/CC/CV (long press)
9. Selects panel control, gun control unit or hand-held control unit (short press).
Turns memory channel remote selection ON/OFF (long press).
10. Power control knob
11. Arc length and voltage control knob.
Automatic weld data display
Last recorded welding values are displayed post welding.
3.3

Button functions

3.3.1 ON/OFF button (1)
Short press: XF 37 panel returns to initial display.
Long press: XF 37 panel is turned ON or OFF.
When wire feeder XF 37 control panel is turned ON, also the power source control panel X 37
NOTE!
turns on and links automatically to this wire feeder.
CH REMOTE
CHANNEL
WISEROOT
© Kemppi Oy / 1312
1. 2. 3.
WISEROOT 4T
+
2T
7.
/
4T
+
2T
4.
11.
/
PANEL
XF 37
8. 9.
PANEL
XF 37
EN
13