Kemppi FastMig MXP 37 Pipe Steel Operating Manual page 16

3.3.2 Dynamics button (2)
Short press: Dynamics setting for 1-MIG, synergic MIG and CC/CV. ArcForce setting for MMA.
Long press: Wire feeder number selection. If there is more than one wire feeder connected to
the system, you can select which of them is active. Each wire feeder has its own number (1–3).
NOTE!
3.3.3 Gas test button (3)
CH REMOTE
CHANNEL
WISEROOT
This button displays the gas test time. You can change it with the control knob.
Gas test starts when the time adjustment is made, after a short delay.
You can stop gas test by pressing any button.
EN
3.3.4 Wire inch button (3)
EMOTE
ANNEL
WISEROOT
+
This button starts starts feeding the wire with the default speed of 5 m/min. The wire feed
stops when you release the button.
You can change the wire feed speed with the control knob. The changed speed is used if you
press the button again.
3.3.5 Channel down button (5)
CH REMOTE
CHANNEL
OOT 4T
+
This button selects the previous memory channel that can be found.
2T
3.3.6 Channel up button (6)
Short press: Selects the next memory channel that can be found.
Long press: Locks or unlocs the selected memory channel. No parameter changes are allowed
to a locked memory channel.
3.3.7 2T/4T button (7)
MOTE
NNEL
WISEROOT
+
Short press: Toggles between 2T or 4T gun trigger mode.
Long press: Turns MatchLog ON/OFF. This can be either MatchChannel or Minilog
functionality, depending on which one is defined in the selected memory channel. If neither
one is defined, this selection is unavailable.
14
FastMig MXP 37 Pipe
Wire feeder number is not available in MMA, CC and CV processes.
/
4T
+
2T
/
4T
2T
CH REMOTE PANEL
CHANNEL
WISEROOT
+
XF 37
/
PANEL
WISEROOT 4T
+
2T
XF 37
/
4T
2T
PANEL
XF 37
PANEL
XF 37
/
4T
2T
PANEL
/
XF 37
PANEL
XF 37