This operating manual contains important information on the use, maintenance and safety of your Kemppi product. The technical specifications of the equipment can be found at the end of the manual. Please read the manual carefully before using the equipment for the first time. For your own safety and that of your working environment, pay particular attention to the safety instructions in the manual.
PRODUCT INTRODUCTION FastMig MF is basic wire feeder designed for demanding enviroment. It can be used with Kemppi's basic FastMig power sources KM 300, KM 400, and KM 500. Operation control and connectors Control panel Connection for control cable Welding gun EURO connector...
The flow rate is set according to the welding power used in the job. A suitable flow rate is normally 8 – 10 l/min. If the gas flow is not suitable, the welded joint will be sporous. Contact your local Kemppi-dealer for choosing gas and equipment. FastMig MF 29...
Read in operation instructions for the FastCool 10 unit the trouble situations of the liquid circulation system and protection against torch etc. damage. 3.12 Hanging MF 29 can be hanged to the barrier with an optional hanging frame (6185285). The machine is not supposed to be hanged from its handle. SERVICE, OPERATION DISTURBANCES The amount of use and the working environment should be taken into consideration when planning the frequency of maintenance of MF.
The owner of the equipment is obliged to deliver a decommissioned unit to a regional collection centre, per the instructions of local authorities or a Kemppi representative. By applying this European Directive you will improve the environment and human health.
Need help?
Do you have a question about the MF 29 and is the answer not in the manual?
Questions and answers