Main Switch I/O; Operation Of Cooling Unit, Fastcool 10; Hanging Kit; Xf 37 Control Panel - Kemppi FastMig MXP 37 Pipe Steel Operating Manual

2.14 Main switch I/O

When you turn the main switch of the FastMig power source into I-position, the pilot lamp
closest to this switch will illuminate, indicating the power source is ready for welding. The
equipment will return to the same operation state where it was before the last shutdown.
Always start and switch off the machine with the main switch, never use the mains plug as a
switch.

2.15 Operation of cooling unit, FastCool 10

When water cooling unit FastCool 10 is connected to the FastMig power source for the
first time, the cooler function is normally active. To deselect the cooler function, follow the
instructions stated in the FastCool 10 operating manual.

2.16 Hanging kit

The MXP 37 Pipe wire feed units can be mounted on a welding boom using the KFH 1000
hanging device available as an accessory. This allows the wire feed unit to be suspended
above the work area.
EN
3.

XF 37 CONTROL PANEL

3.1

Connecting and mounting

Fasten the ribbon cable connector from the MXP 37 Pipe wire feed unit to the control panel.
Attach the yellow-green earth lead into the fork connector on the XF 37 control panel.
12
FastMig MXP 37 Pipe
+