Operation Of Cooling Fan; Manual Metal Arc Welding; Using The Machine; Arc Wizard, Setup Panel P65 - Layout - Kemppi 350 Operating Manual

3.3

OPeratiOn OF COOling Fan

FastMig Pulse power sources incorporate two simultaneously operating fans.
• The fan is started momentarily when the main switch is placed into position - I.
• The fan will start during welding as the machine reaches operational temperature, and
it will run for 1 to 10 minutes after the welding has stopped, depending on the welding
cycle completed.
3.4

Manual Metal arC welding

FastMig Pulse power source can be used for MMA electrode welding by connecting the
FastMig MXF wire feeding unit and PF function panel. MMA function is optional in FastMig
Pulse equipment, and therefore can be activated by purchasing the appropriate licence for the
MMA process. Please see ordering number codes. FastMig Pulse power source will not support
the MMA process without an MXF wire feeder connected.
4.

using the MaChine

Welding applications vary, so the equipment must adapt. FastMig Pulse features Arc Wizard
P65 interface, a clear and logical LCD menu display. Arc Wizard menu allows the operator
to refine, adapt and manage the arc process and system function before, during and after
welding.
4.1 arC wizard, setuP Panel P65 – layOut
1.
CHANNEL
8.
4.2 setuP Panel P65 – quiCk guide
The following information details P65 panel operation and set-up. Additional information
is also available in the printed 'Quick Guide' for P65 and PF function panels. Quick Guide is
included in the delivery package, plus pdf copy recorded to CD.
introduction to P65 button functions
1. Switch P65 ON/OFF by long pressing on this button (approximately 5 seconds). Also returns
channel information display by short press.
For true ON/OFF switching of the mains power, use the main switch I/O – ON/OFF located
NOTE!
on the front of the power source.
2. 7. 3.
MENU
CHANNEL USER WF #
INFO F1 F2
6.
4.
F3
P 65
5.
EN
9