Kemppi FastMig MXP 37 Pipe Steel Operating Manual page 17

H REMOTE
HANNEL
WISEROOT
+
WISEROOT 4T
+
2T
CH REMOTE
CHANNEL
OTE
NEL
WISEROOT 4T
+
2T
3.3.8 Extra functions button (8)
/
4T
2T
PANEL
XF 37
Short press: Selects Crater fill or Hot start function.
Long press: Turns MMA/CC/CV mode ON/OFF.
3.3.9 Remote Selection Button (9)
/
PANEL
XF 37
Short press: Toggles the control between the control panel, gun remote control unit and
hand-held remote control unit.
If RemoteAutoRecog setting is ON in X 37 control panel, you can select only those remote
NOTE!
controls, which can be found in the system.
Long press: Turns the memory channel remote selection ON/OFF. This is available only if you
have selected either gun remote control unit or hand-held remote control unit. Not available
in MMA/CC/CV mode.
3.3.10 Power control knob (10)
This control knob adjusts
• wire feed speed or power in MIG/MAG processes (before or during welding)
WISEROOT 4T
+
• MMA/CC current level (before or during welding)
• selected parameter values. 2T
3.3.11 Arc length and voltage control knob (11)
This control knob adjusts the arc length, voltage or selected parameter values before or
/
during welding.
PANEL
XF 37
© Kemppi Oy / 1312
/
PANEL
XF 37
EN
15