On-Board Ethernet Diagnostic Leds - Bosch B5512 Reference Manual

40 en | IP communications
2.
3.
4.
For more information on using AutoIP, refer to AutoIP.
8.1.3

On-board Ethernet diagnostic LEDs

The control panel includes the following on-board LEDs to assist with troubleshooting the on-
board Ethernet connection.
Figure 8.1: On-board Ethernet and LEDs (B5512 shown)
Callout ᅳ Description
1 ᅳ 100BASE-T LED (green)
2 ᅳ LINK LED (yellow)
Refer to the following tables for information on the 100BASE-T and LINK LEDs.
Flash pattern
Table 8.1: 100BASE-T LED descriptions
2015.07 | 12 | F.01U.287.180
Connect the control panel to the RPS computer using the Ethernet ports and a standard
Ethernet cable, and apply power to the control panel, if applicable. Within 2 minutes, the
RPS computer assigns an IP address using AutoIP.
In RPS, open the control panel account and click the Connect button. From the Connect
Via drop-down list select IP Direct. Click Connect. Once connected, perform the
necessary tasks, and disconnect when finished.
Reconnect the cable used for IP communication, if applicable.
MODULE 1
E 1
1
100BASE-T
2
LINK
On Steady
Off
Installation and System Reference Guide
MODULE
RELEASE
ETHERNET
USB
Function
Communicating at 100 Mb
Communicating at 10 Mb.
Control Panel
Bosch Security Systems, Inc.