On-Board Ethernet Diagnostic Leds - Bosch B6512 Installation Manual

Hide thumbs Also See for B6512:
Table of Contents

Advertisement

Control Panels
2.
3.
4.
For more information on using AutoIP, refer to AutoIP, page 144.
8.1.3

On-board Ethernet diagnostic LEDs

The control panel includes the following on-board LEDs to assist with troubleshooting the on-
board Ethernet connection.
Figure 8.1: On-board Ethernet and LEDs (B5512 shown)
Callout ᅳ Description
1 ᅳ 100BASE-T LED (green)
2 ᅳ LINK LED (yellow)
Refer to the following tables for information on the 100BASE-T and LINK LEDs.
Flash pattern
Tab. 8.2: 100BASE-T LED descriptions
Flash pattern
Bosch Security Systems, Inc.
Connect the control panel to the RPS or Installer Services Portal programming tool
computer using the Ethernet ports and a standard Ethernet cable, and apply power to the
control panel, if applicable. Within 2 minutes, the RPS or Installer Services Portal
programming tool computer assigns an IP address using AutoIP.
In RPS or the Installer Services Portal programming tool, open the control panel account
and click the Connect button. From the Connect Via drop-down list select IP Direct. Click
Connect. Once connected, perform the necessary tasks, and disconnect when finished.
Reconnect the cable used for IP communication, if applicable.
MODULE 1
E 1
1
100BASE-T
2
LINK
On Steady
Off
On Steady
MODULE
RELEASE
ETHERNET
USB
Function
Communicating at 100 Mb.
Communicating at 10 Mb.
Function
Plugged into an Ethernet network.
Communication in progress.
Installation Manual
IP communications | en
33
2018.07 | 16 | F.01U.287.180

Advertisement

Table of Contents
loading

This manual is also suitable for:

B5512B4512B4512eB3512eB3512B5512e

Table of Contents