Users Menu Parameters - Bosch B5512 Reference Manual

Control Panel
Keypad 7
Keypad 8
Scope
B91x/B92x keypads configuration of Scope
1.
2.
3.
4.
5.
6.
7.
B93x/B94x keypads configuration of Scope
1.
2.
3.
4.
5.
6.
7.
19.1.15

[6] Users menu parameters

In this menu, you can change the Service User passcode and the passcode for User 1.
To add and remove users, change users passcodes, and perform other user functions from the
keypad, you must use the Users menu from the Main menu. Refer to the Control Panels
(B9512G/B8512G/B5512/B4512/B3512) Owner's Manual for more information.
Users (In the Installer menu)
B91x/B92x keypads configuration of Users
1.
2.
3.
4.
5.
6.
7.
B93x/B94x keypads configuration of Users
1.
2.
3.
Bosch Security Systems, Inc.
Scope (Circle one)
No Device / Area Wide / Acct Wide / Panel Wide
No Device / Area Wide / Acct Wide / Panel Wide
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [5] Keypad. The keypad shows scope for the selected keypad.
Use [PREV] or [NEXT] to go to the desired keypad.
Press [ENTER] to edit the scope.
Use [PREV] or [NEXT] to go to the desired scope.
Press [ENTER] while viewing the desired scope to save the new format selection.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [5] Keypad. The keypad shows scope for the selected keypad.
Use /[PREV] or /[NEXT] to go to the desired keypad.
Press [Edit] to edit the scope.
Press the icon or softkey for the desired format.
Press [Save].
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [6] Users. The keypad shows the Installer passcode.
Use [PREV] or [NEXT] to toggle between user 000 (service user) and user 001 and go to
the user you want to edit.
Press [ENTER] to edit the selected user. The curser flashes at the editing location.
Delete existing characters, if necessary, and then enter the new characters.
Press [ENTER] to save the change.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [6] Users menu. The keypad shows the user passcode for the
selected user.
Use /[PREV] or /[NEXT] to toggle between user 000 (service user) and user 001 and
go to the user you want to edit.
Installation and System Reference Guide
Keypad Installer menu | en
2015.07 | 12 | F.01U.287.180
123