Bosch B5512 Reference Manual page 111

Control Panel
B93x/B94x keypads configuration of Primary Destination Device
1.
2.
3.
4.
5.
6.
7.
8.
Backup Destination Device
Notice!
Keypads show and allow you to select the Backup Destination Device only after you select a
Primary Destination Device.
B91x/B92x keypads configuration of Backup Destination Device
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Press [ENTER] to save the change, and then escape from the menu.
B93x/B94x keypads configuration of Backup Destination Device
1.
2.
3.
4.
5.
Bosch Security Systems, Inc.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [1] Reporting > [3] Routing. The keypad shows the primary device
for the selected route.
Use /[PREV] or /[NEXT] to scroll though the list of routes and go to the route you
want to program.
Press [Edit] to edit the primary destination device for the selected route.
Use /[PREV] or /[NEXT] to scroll though the list of devices (for destination 1) and go
to the destination 1 option you want to select for the current device (for example, Phone
1).
To keep destination 1, escape from the menu. To change to a different destination (2, 3,
or 4), press [Edit Destination] and continue to Step 8.
Delete existing characters, if necessary, and then enter the new number.
Press [Save] to save the change, and then escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [1] Reporting > [3] Routing. The keypad toggles between showing
the current primary and backup setting for the selected route.
Use [PREV] or [NEXT] to scroll though the list of route and go to the route you want to
program.
Press [ENTER] to edit the route.
Press [NEXT] to go to the option to edit the backup route.
Press [ENTER]. The keypad shows Set Route Device.
Use [PREV] or [NEXT] to scroll though the list of device (for destination 1) and go to the
destination 1 option you want to select for the current device (for example, Phone 1).
Press [ENTER] to select the device. The keypad shows Set route dest 1-4. To keep
destination 1, escape from the menu. To change to a different destination (2, 3, or 4),
continue to Step 9.
Delete the current number, and then enter the new number.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [1] Reporting > [3] Routing. The keypad shows the primary device
for the selected route.
Use /[PREV] or /[NEXT] to scroll though the list of routes and go to the route you
want to program.
Press [Backup] to edit the backup destination device for the selected route.
Use [PREV] or [NEXT] to scroll though the list of devices (for destination 1) and go to the
destination 1 option you want to select for the current device (for example, Phone 1).
Installation and System Reference Guide
Keypad Installer menu | en
2015.07 | 12 | F.01U.287.180
111