Network > [1] Ethernet > (Choose The Bus Module Or On-Board) > [3] Dns - Bosch B5512 Reference Manual

116 en | Keypad Installer menu
B93x/B94x keypads configuration of HTTP Port Number
1.
2.
3.
4.
5.
6.
19.1.7 [2] Network > [1] Ethernet > (choose the bus module or on-board) > [3]
DNS Parameters menu
IPv4 Server Address
B91x/B92x keypads configuration of IPv4 Server Address
1.
2.
3.
4.
5.
6.
B93x/B94x keypads configuration of IPv4 Server Address
1.
2.
3.
4.
5.
6.
IPv6 Server Address
B91x/B92x keypads configuration of IPv6 Server Address
1.
2.
3.
4.
5.
6.
2015.07 | 12 | F.01U.287.180
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [2] Network > [1] Ethernet > (choose the bus module or on-board) >
[2] Address Parameters > [4] HTTP Port Number.
Press [HTTP Port Number] to edit the port number.
Delete the existing number, if necessary, and then enter the new number.
Press [Save] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [2] Network > [1] Ethernet > (choose the bus module or on-board) >
[3] DNS Parameters > [1] IPv4 Server Address. The keypad shows the IPv4 Server
Address current configuration.
Press [ENTER] to edit the IPv4 Server Address.
Delete the existing number, if necessary, and then enter the new number. Use [PREV] or
[NEXT] to move to a different byte.
Press [ENTER] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [2] Network > [1] Ethernet > (choose the bus module or on-board) >
[3] DNS Parameters [1] IPv4 Server Address. The keypad shows the DHCP/AutoIP current
configuration.
Press [IPv4 Server Address] to edit the IP address.
Delete the existing number, if necessary, and then enter the new number. Use
or /[NEXT] to move to a different byte.
Press [Save] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [2] Network > [1] Ethernet > (choose the bus module or on-board) >
[3] DNS Parameters > [2] IPv6 Server Address. The keypad shows the IPv4 Server
Address current configuration.
Press [ENTER] to edit the IPv6 Server Address.
Delete the existing number, if necessary, and then enter the new number. Use [PREV] or
[NEXT] to move to a different byte.
Press [ENTER] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Installation and System Reference Guide
Control Panel
/[PREV]
Bosch Security Systems, Inc.