Signal Strength And Diagnostic Leds - Bosch B5512 Reference Manual

42 en | IP communications
Plug the module into a control panel by aligning the module with the control panel's on-board
connector. The retention clip has a locking device to help hold the card in position. Pull the
locking device back. Align the PCB metal contacts with the on-board connector. Push the
module into place. The retention clip snaps closed and secures the module in place.
Wire to the antenna
The module has a threaded connector for connection to an antenna. Route the antenna cable
through a wire knockout in the top of the enclosure. Connect the antenna cable to the
module. Secure the antenna cable to the outside of the enclosure.
Figure 8.2: Plug-in celluar module wiring (B440 and B5512 shown)
8.2.3

Signal strength and diagnostic LEDs

Five LED patterns indicate that you correctly secured the module in the control panel, and
indicate the signal strength obtained by the module.
LED
2015.07 | 12 | F.01U.287.180
Blue
Red
Yellow
Green (1 light)*
Installation and System Reference Guide
Function
Indicates the overall status of the device.
Indicates an unacceptable signal strength
level.
Indicates a marginal signal strength level.
Indicates a good signal strength level.
Control Panel
Bosch Security Systems, Inc.