Rps > [4] Rps Port Number Menu Parameters; Area Options Menu Parameters - Bosch B5512 Reference Manual

Control Panel
7.
19.1.12 [3] RPS > [4] RPS Port Number menu parameters
In this menu, you can specify the destination port for outgoing RPS session requests to the
specified IP address.
RPS Port Number
B91x/B92x keypads configuration of RPS Port Number
1.
2.
3.
4.
5.
6.
B93x/B94x keypads configuration of RPS Port Number
1.
2.
3.
4.
5.
6.
19.1.13

[4] Area Options menu parameters

This parameter enables or disables specified areas. Enabled areas must have assigned account
numbers. In this menu, you can turn on or off areas and assign area account numbers.
Notice!
Account numbers can contain characters 0 through 9, and B through F.
Area On
Account Number
Area On
B91x/B92x keypads configuration of Area On
1.
2.
3.
4.
5.
6.
7.
Bosch Security Systems, Inc.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [3] RPS > [3] RPS Port Number.
Press [ENTER] to edit RPS port number.
Delete the existing number, if necessary, and then enter the new number.
Press [ENTER] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [3] RPS > [3] RPS Port Number.
Press [Edit] to change the port number.
Delete the existing number, if necessary, and then enter the new number.
Press [Save] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Area 1
Yes/No
______________
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [4] Area Options. The keypad toggles between showing the Area On
state and the account number for the selected areas.
Use [PREV] or [NEXT] to go to the desired area.
Press [ENTER] to edit the area and then [ENTER] to edit the Area On state for the
selected area.
Use [PREV] or [NEXT] to toggle between Yes and No.
Press [ENTER] while viewing the desired option to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Installation and System Reference Guide
Area 2 Area 3
Yes/No Yes/No
______________ ______________
Keypad Installer menu | en
Area 4
Yes/No
______________
2015.07 | 12 | F.01U.287.180
121