Control Panel Installation; Install The Enclosure And Wiring Label; Install The Control Panel; Mount The Control Panel - Bosch B5512 Reference Manual

Control Panel
5

Control panel installation

This section explains how to mount the control panel enclosure, how to mount the control
panel into the enclosure, and provides an overview of how to wire modules to the control
panel.
5.1

Install the enclosure and wiring label

Refer to Enclosures, page 94 to determine if the application requires a specific enclosure.
Installing the enclosure:
1.
2.
3.
4.
Notice!
Electromagnetic interference (EMI) can cause problems on long wire runs.
Figure 5.1: Enclosure and control panel mounting (B10 shown)
Callout ᅳ Description
1 ᅳ Control panel wiring label
2 ᅳ Enclosure mounting holes (4)
3 ᅳ Module mounting locations (4)
4 ᅳ Tamper switch mounting location
5 ᅳ Control panel mounting location
5.2

Install the control panel

This section includes instructions to mount the control panel in the enclosure, connect earth
ground, and make other control panel connections.
5.2.1

Mount the control panel

1.
Bosch Security Systems, Inc.
Remove any knockouts prior to installing the control panel.
Mount the enclosure in the desired location. Use all enclosure mounting holes. Refer to
the mounting instructions supplied with the selected enclosure.
Pull the wires into the enclosure.
Install the supplied Enclosure Wiring Label (B5512/B4512/B3512) on the inside of the
enclosure door.
1 2
2
Identify the control panel mounting location in the enclosure.
Installation and System Reference Guide
3 2
3
4
5 2
Control panel installation | en
2015.07 | 12 | F.01U.287.180
23