Bosch B5512 Reference Manual page 45

Control Panel
Wire the module
When you wire an SDI2 module to a control panel, you can use either the terminal strip
labeled with PWR, A, B, and COM to wire to corresponding terminals labeled PWR, A, B, and
COM on the control panel, or you can use the interconnect wiring connector and the included
interconnect cable.
For terminal wiring, use 18 AWG to 22 AWG (1.02 mm to 0.65 mm) wire.
Notice!
Use either the terminal strip wiring or interconnect wiring to the control panel. Do not use
both. When connecting multiple modules, you can combine terminal strip and interconnect
wiring connectors in series.
3
Figure 8.3: B426 to control panel wiring - terminal strip or interconnect wiring connector (B5512 shown)
Callout ᅳ Description
1 ᅳ Control panel
2 ᅳ Module
3 ᅳ Terminal strip wiring
4 ᅳ Interconnect cable (P/N: F01U079745) (included)
The module has an Ethernet RJ-45 port for connection to an Ethernet network. Connect an
Ethernet cable between the Ethernet jack on the module and a network jack.
Bosch Security Systems, Inc.
SDI2 ON-BOARD POINTS
Device Bus
1 Voltage Ranges
R Y G B
Open 3.7 - 5.0 VDC
Normal 2.0 - 3.0 VDC
Short 0.0 - 1.3 VDC
1 k End of Line Resistors
AUX
1 COM 2 3 COM 4 5 COM 6
- 12 V +
COM AUX R Y G B 1 COM 2 3 COM 4 5 COM
PWR A B COM
2
R
Y
G
B
Installation and System Reference Guide
C
OUTPUT
B
7 COM 8
6 7 COM 8
R
R
2
Y
Y
G
G
B
B
IP communications | en
SDI2 ON-BOARD POINTS
Device Bus
1
Voltage Ranges
R Y G B
Open 3.7 - 5.0 VDC
Normal 2.0 - 3.0 VDC
Short 0.0 - 1.3 VDC
1 k End of Line Resistors
AUX
1 COM 2 3 COM 4 5 COM 6
- 12 V +
COM AUX R Y G B 1 COM 2 3 COM 4 5 COM
PWR A B COM
4
2015.07 | 12 | F.01U.287.180
45
C
OUTPUT
B
7 COM 8
6 7 COM 8