Control Panels
5
Control panel installation
Refer to Enclosures, page 86 to determine if the application requires a specific enclosure.
Enclosure overview
Callout ᅳ Description
1 ᅳ Control panel wiring label
2 ᅳ Enclosure mounting holes (4)
3 ᅳ Three-hole pattern for mounting modules (4)
4 ᅳ Mounting location for the tamper switch
5 ᅳ Mounting location for the control panel
5.1
Installing the enclosure and wiring label
Notice!
Electromagnetic interference (EMI)
EMI can cause problems on long wire runs.
1.
2.
3.
4.
5.2
Installing the control panel
1.
Bosch Security Systems, Inc.
1
Remove the knockouts.
Mount the enclosure. Use all enclosure mounting holes. Refer to the mounting
instructions supplied with the selected enclosure.
Pull the wires into the enclosure through the knockouts.
Position the supplied enclosure wiring label on the inside of the enclosure door.
Identify the control panel mounting location in the enclosure.
2
2
Installation Manual
Control panel installation | en
3
2
5
2
2018.07 | 16 | F.01U.287.180
17
3
4