Network > [1] Ethernet > (Choose The Bus Module Or On-Board) > [3] Dns - Bosch B6512 Installation Manual

Control Panels
4.
5.
6.
Default Gateway
1.
2.
3.
4.
5.
6.
HTTP Port Number
1.
2.
3.
4.
5.
6.
20.1.7 [2] Network > [1] Ethernet > (choose the bus module or on-board) > [3]
DNS Parameters menu
IPv4 Server Address
1.
2.
3.
4.
5.
6.
IPv6 Server Address
1.
2.
3.
4.
5.
6.
Bosch Security Systems, Inc.
Delete the existing number, if necessary, and then enter the new number. Use
Previous or /Next to move to a different byte.
Press Save or Enter. The keypad shows Parameter saved.
Escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [2] Network > [1] Ethernet > (choose the bus module or
on-board) > [2] Address Parameters > [3] Default Gateway.
Press Edit or Enter to edit the gateway.
Delete the existing number, if necessary, and then enter the new number. Use
Previous or /Next to move to a different byte.
Press Save or Enter. The keypad shows Parameter saved.
Escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [2] Network > [1] Ethernet > (choose the bus module or
on-board) > [2] Address Parameters > [4] Port Number.
Press Edit or Enter to edit the port number.
Delete the existing number, if necessary, and then enter the new number.
Press Save or Enter. The keypad shows Parameter saved.
Escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [2] Network > [1] Ethernet > (choose the bus module or
on-board) > [3] DNS Parameters > [1] IPv4 Server Addr. The keypad shows the IPv4
Server Address current configuration.
Press Edit or Enter to edit the IPv4 Server Address.
Delete the existing number, if necessary, and then enter the new number. Use
Previous or /Next to move to a different byte.
Press Save or Enter. The keypad shows Parameter saved.
Escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [2] Network > [1] Ethernet > (choose the bus module or
on-board) > [3] DNS Parameters > [2] IPv6 Server Addr. The keypad shows the IPv6
Server Address current configuration.
Press Edit or Enter to edit the IPv6 Server Address.
Delete the existing number, if necessary, and then enter the new number. Use
Previous or /Next to move to a different byte.
Press Save or Enter. The keypad shows Parameter saved.
Escape from the menu.
Installation Manual
Keypad Installer menu | en 107
/
/
/
/
2018.07 | 16 | F.01U.287.180