Oce BLM 500 Operating Information Manual page 87

[45]
Step
1
2
3
4
Result
The error message 'MANUALLY PARK SHUTTLE' is cleared from the screen.
The shuttle axis re-references and the message 'Shuttle axis moving' is displayed.
When the message list is clear, you can continue operation
Open the folder cover.
Push the shuttle-assembly to
the right.
Wait until the error message
'SHUTTLE NOT PARKED'
is cleared from the screen.
Close the folder cover.
Manually park the Shuttle
Open and Close the Folder Cover
on page 37
figure 45 on page 86
correct position for the shuttle
assembly.
If the shuttle assembly does not
move to the correct position, push
the pick-up fingers away from each
other by 2-3mm and try again.
Repeat if necessary.
If the message does not clear, check
that the shuttle assembly is in the
correct position. Repeat Step 2 if
necessary.
shows the
87