Oce BLM 500 Operating Information Manual page 67

Spine Form
[28]
[29]
Condition
Incorrect - The spine needs more form.
Check these settings:
The SET THICKNESS
setting is incorrect
The folder cover is not
securely closed?
The FORM function is
not turned on?
The THRESHOLD
value is less than the SET
THICKNESS?
Does the spine need more
form at one end?
Does the spine need more
form at each end?
Incorrect - The spine is damaged or there are
creases near the spine.
Check these settings:
The SET THICKNESS
setting is incorrect?
The spine of the book
needs less forming.
Book Quality
Measure the set thickness
and enter the correct
dimension. Enter the Job
Settings on page 14
Close the folder
cover.Close the Folder
Cover on page 37
Turn on the FORM
function. See "FORM" in
table 9 on page 25
Decrease the
THRESHOLD value.
See THRESHOLD
table 9 on page 25
Change NUMBER to 2
or 4. See "FORM" in
table 9 on page 25
Increase PRESSURE.
Then, if the spine still
needs more form,
increase NUMBER. See
"FORM" in table 9 on
page 25
Measure the set thickness
and enter the correct
dimension. Enter the Job
Settings on page 14
Decrease PRESSURE.
Then, if the spine is still
over formed, decrease
NUMBER. See "FORM"
in table 9 on page 25
67