Oce BLM 500 Operating Information Manual page 64

Book Quality
[27]
Book Quality
Problem
The finished book
is not neat and tidy
The sheets are not
aligned
The spine is not
formed correctly
The book is not
trimmed
The book is not
trimmed square
The trimmed edge
is of bad quality
64 Chapter 5 Error Conditions, Problems, and Solutions
Cause
The wrong paper size was
entered on the touch screen.
The book is made from
paper that is different sizes.
The Booklet maker
adjustment system is not
calibrated correctly.
The static elimination bars
are dirty.
Incorrect function of the
static elimination bars.
Incorrect settings.
The TRIM function is not
selected.
The trim position is set
larger than the book.
Trimmed paper has
collected on the trim stop.
The trimmer blade is blunt
or damaged.
Solution
Measure the paper and enter
the correct dimensions
'Enter the Job Settings' on
page 14).
Only use paper of the same
size (see 'Paper Size and Book
Quality Instructions' on
page 63).
Touch RE-REF in the
ADVANCED window to
calibrate the Booklet maker
adjustment axes. (see table 11
on page 29)
Clean the static elimination
bars (see 'Clean the Static
Elimination Bars' on
page 92).
Call your service engineer.
(see 'Spine Form Problems'
on page 66)
Turn on the TRIM function.
See "TRIM" in table 9 on
page 25
Reset the trim position. See
"TRIM" in (see table 9 on
page 25)
Clear the trimmed paper from
the trim stop. (see 'Jam in the
Trim Area' on page 74)
Call your service engineer.
(see