Oce BLM 500 Operating Information Manual page 56

Error Messages
Problem
FLOW ERROR -
FORMER
FLOW ERROR -
OUTFEED
Fold blade axis moving
FOLD BLADE NOT
PARKED
56 Chapter 5 Error Conditions, Problems, and Solutions
Cause
There is an error at the
former. Open the folder
cover and remove the
book(s). If necessary,
open the main deck to
remove the book(s).
If there is paper in the
gathering area, touch
START, then touch
ADVANCED > PURGE
SET > PURGE SET to
clear the set from the
machine.
There is an error at the
outfeed. Check the
outfeed. If necessary,
remove the trim bin and
open the trim stop guard
to remove the book(s).
Touch STOP to clear the
message from the screen.
If there is paper in the
gathering area, touch
START, then touch
ADVANCED > PURGE
SET > PURGE SET to
clear the set from the
machine.
The fold blade axis (book
thickness adjustment) is
moving. This message
clears when the
adjustment is complete.
If the message does not
clear, touch ADVANCED
> RE REF
The fold blade is in the
wrong position. Touch
START to reset the
position. Follow the
instructions on the screen.
Solution
Jam in the Folder or
Former Area on page 72
Jam in the Trim Area on
page 74