Oce BLM 500 Operating Information Manual page 58

Error Messages
Problem
JAM IN GATHERING
AREA
JAM IN STACKER
AREA
JAM IN STITCHER
AREA
JAM IN STITCH HEAD
JAM IN TRIMMER
MANUALLY PARK
SHUTTLE
MISSING STITCHES
MOTOR CONTROLLER
NOT READY
58 Chapter 5 Error Conditions, Problems, and Solutions
Cause
There is a paper jam in the
gathering area. Open the
connecting bridge cover,
lift the connecting bridge
and remove the paper
jam.
There is a paper jam at the
outfeed of the machine.
Remove the jammed
books and continue.
There is a paper jam in the
stitch area. Open the
folder cover, remove the
paper jam and continue.
There is a jam in the stitch
head.
There is a book jammed
in the trimmer. Clear the
jam and continue.
The shuttle is not parked
correctly. Open the folder
cover and move the
shuttle to the park
position. Close the folder
cover. The shuttle will
reset. When the message
list is clear, continue
operation.
The machine has detected
missed stitches. Check to
see whether the
stitch-wire is jammed or
whether the stitch-wire
spool is empty.
The drive motor
controller is not ready. If
the problem continues,
contact your service
engineer.
Solution
(see 'Jam in the
Gathering Area' on
page 71)
(see 'Jam in the Stitch
Area' on page 72)
Clear a Stitch Head Jam
on page 80
(see 'Jam in the Trim
Area' on page 74)
Manually park the Shuttle
on page 86
(see 'Clear a Stitch Wire
Jam' on page 77)
(see 'Install New Stitch
Wire' on page 107)