Oce BLM 500 Operating Information Manual page 15

Procedure for a New Job
[5]
Step
1
2
3
4
5
6
7
8
9
Procedure for a Saved Job
Touch LOAD & SAVE
1.
Action
Touch BASIC
Enter the paper
size
Enter the page
direction
Enter the page
rotation setting
Enter the set
thickness.
Enter the number
of stitches.
Enter the spine
form setting
Enter the trim
setting.
Touch CLOSE
If needed, save the
job settings to
memory.
Information
Touch PAPER SIZE. Enter the dimensions of the
paper.
The job setting is easier if you first select a preset
paper size, then adjust the settings as necessary
Touch PAPER SIZE > PRESETS > A3 or A4. (USA:
11x17, 8.5x11 or 8.5x14)
Touch PAGE DIRECTION > LANDSCAPE or
PORTRAIT.
If the PAGE DIRECTION option is not available, the
PAGE DIRECTION cannot be changed.
For A4 paper size, the normal setting for ROTATE is
ON. Rotation lets the printer operate at optimum
speed.
Touch ROTATE to turn the sheet rotation ON or OFF.
Always select the page direction before you change
the rotate setting.
Touch SET THICKNESS. Enter the measured value.
Touch STITCHES and enter the number of stitches.
If needed, the stitch pitch can be changed. See
"STITCH PITCH," table 9 on page 25
The spine form setting is automatic, according to the
SET THICKNESS setting. If needed, the setting can
be changed. See "FORM" in
The trim setting is automatic, according to the PAGE
SIZE and SET THICKNESS settings. To change the
setting, touch TRIM. See "TRIM" in
page 27
If the same job settings are used frequently, then save
the job settings to memory.
See "Save a job."Load and Save the Job Settings on
page 34
Enter the Job Settings
table 9 on page 25
table 10 on
15