Oce BLM 500 Operating Information Manual page 83

[44]
Step Action
1 Lift the Booklet maker main
deck.
2 Remove the wire-holder
from the stitch head.
3 Inspect the area behind the
wire-holder for stitch-wire.
4 Remove any stitches or
pieces of stitch-wire and
clean the area with the air
duster.
5 Lubricate the stitch-head.
6 Fit the wire-holder.
7 Close the Booklet maker.
8 Start the Booklet maker.
Clear a Stitch Head Jam
Information
See Lift the Booklet maker Main Deck
on page 41
Move the wire-holder retaining
spring to the right.
page 81
Remove the wire-holder
If the wire-holder is held in position,
use a screwdriver to help remove the
wire-holder from the stitch head.
[44]
figure 43 on page 82
Use wire cutters to remove any
jammed stitches or pieces of
stitch-wire.
Lubricate the Stitch Head on
page 102
Remember to put the wire-holder
retaining spring in position.
If the head operates normally and
returns to the parked position, then
further action is not needed.
If the stitch-head remains jammed,
then repeat the procedure again.
If the problem continues, contact
your service engineer.
figure 42 on
83