Oce BLM 500 Operating Information Manual page 78

Clear a Stitch Wire Jam
[38]
A
B
C
D
Before You Begin
[39]
Step
1
2
3
Clear the Jammed Wire
[40]
Step
1
2
3
78 Chapter 5 Error Conditions, Problems, and Solutions
Top location of Middle Wire Tube
Middle Wire Tube
Metal Spring Clip
Feed Gears
Action
Turn off the Booklet maker
Disconnect the Booklet maker
from the power supply.
Lift the Booklet maker main
deck
Action
Cut the stitch wire at position
'A' approximately 50mm (2
inches) from where the stitch
wire leaves the stitch wire
guide.
Cut the stitch wire at position
'B' between the feed gears
and the middle wire tube.
Pull the stitch wire from the
stitch wire guide block.
Information
Use the ON/OFF switch.
(see 'Lift the Booklet maker Main
Deck' on page 41)
Information
[38]
A
Detail A: Cut stitch wire here.
[39]
B
Detail B: Cut stitch wire here.
[40]
Pull stitch wire in direction of arrow