Oce BLM 500 Operating Information Manual page 59

Problem
REMOVE SET FROM
FOLD AREA
REMOVE SET -
GATHERING AREA
Rotate axis moving
SET IN GATHERING
AREA
Shuttle axis moving
SHUTTLE MOTOR
COMMS FAIL
Cause
Open the folder cover and
remove the set.
Open the gathering area
and remove the sheets.
Or touch START, then
touch ADVANCED >
PURGE SET > PURGE
SET to clear the set from
the machine.
The rotate axis is moving.
This message clears when
the adjustment is
complete.
If the message does not
clear, touch ADVANCED
> RE REF.
There is a set or partial set
in the gathering area.
If the print job has been
canceled, open the
gathering area and
remove the sheets. Or
touch START, then touch
ADVANCED > PURGE
SET > PURGE SET to
clear the set from the
machine.
The shuttle axis is
moving. This message
clears when the
adjustment is complete.
If the message does not
clear, touchADVANCED
> RE REF.
Use the ON/OFF switch.
Turn the machine OFF,
then turn the machine
ON. If the problem
continues, call your
service engineer.
Error Messages
Solution
59