Oce BLM 500 Operating Information Manual page 104

Lubricate the Stitch Head
Before You Begin
[58]
Step
1.
2.
3.
4.
5.
Apply Grease to the Driver Bar
[59]
Step
1
2
104 Chapter 6 Maintenance
Action
Trim the first part from the
nozzle.
Remove the cap from the tube
of grease.
Fit the nozzle to the tube of
grease.
On the user interface, touch
ADVANCED > STITCHER
UP > STITCHER UP
Lift the Booklet maker main
deck
Action
Use the supplied air duster to
remove dust from the stitch
head.
Remove the wire-holder from
the stitch head.
Information
figure 60 on page 102
The folder cover must be
closed. This action moves the
stitch head to the correct
position for lubrication.
See Lift the Booklet maker
Main Deck on page 41
Information
Move the wire-holder retaining spring
to the right. Then remove the
wire-holder (see Introduction on
page 102)