Oce BLM 500 Operating Information Manual page 111

Step
4
5
Feed the Stitch-wire
[67]
Step
1
3
4
5
6
Action
Close the folder cover.
Close the connecting bridge
cover.
Action
Touch START.
Set the number of stitches to 6 Touch BASIC > STITCHES.
Hand-feed or print an A4 or
larger size test job.
Check that the stitch-wire is
loaded.
Reset the number of stitches
on the touch screen.
Install New Stitch Wire
Information
Information
The stitch-wire loads automatically
during the stitch head cycle.
Check that a stitch is made. If needed,
repeat the previous step.
If a stitch is still not made, repeat the
procedure. Install the stitch-wire into
the stitch head Install the Stitch Wire
into the Stitch Head on page 110.
111