Figure 3-2 Front Card Cage Cover Plate - HP 3000 99x Family Installation Manual

Installation
Gaining Access to the Card Cage
Figure 3-2 Front Card Cage Cover Plate
To verify the presence of PMB cards, you do not have to remove the cover plate. You can see
the PMB cards through holes in the cover plate.
To install/remove PMB cards, you have to remove the cover plate.
To remove the front card cage cover plate, loosen the four (4) thumbscrews (two each at the
upper and lower edges), and lift the cover plate up and out.
To install the cover plate, place the cover plate lip over the raised edge of the cabinet
frame. Tighten the four thumbscrews with a screwdriver so that they are more than
finger-tight. (The torque specification for the thumbscrews is 24-28 inch-lbs.)
Chapter 3 3-9