Service Processor (Sp) Card; Figure 3-5 Attaching A Cover Blank - HP 3000 99x Family Installation Manual

4. While holding the connectors about 1 millimeter apart, tighten the captive screws on
the bulkhead.
5. To avoid damage to the connectors, verify that the connectors on the boards are aligned
properly, then press them together securely by applying even force across the length of
the HSC I/O card connector.
6. Attach cover blanks to any openings on the HP-HSC I/O Bus Converter. Openings occur
where an HSC I/O card has not been attached on an HP-HSC I/O Bus Converter. Cover
blanks must be in place to satisfy EMI emissions and thermal requirements.
7. Tighten the captive screws on the HP-HSC I/O Bus Converter bulkhead to the cover
blank. See Figure 3-5.
Screw the first screw about halfway, tighten the other screw completely, then tighten
the first screw completely.
Figure 3-5 Attaching a Cover Blank

Service Processor (SP) Card

Each system must contain one Service Processor (SP) card located in a dedicated slot (slot
SP in the rear card cage).
Chapter 3
Installation
PMB Cards
3-15