Figure 3-4 Attaching An Hsc I/O Card To An Hp-Hsc I/O Bus Converter - HP 3000 99x Family Installation Manual

Installation
PMB Cards
2. Attach any other HSC I/O cards to the HP-HSC I/O Bus Converters, one per HP-HSC
I/O Bus Converter. (HSC I/O cards include such cards as ATM, Fibre Channel, and F/W
SCSI cards.)
3. If there are more HSC I/O cards than HP-HSC I/O Bus Converters with available slots,
attach a second HP-HSC I/O card to each HP-HSC I/O Bus Converter.
4. Repeat the previous step until you have attached all of the remaining HSC I/O cards.
To attach a card to an HP-HSC I/O Bus Converter:
CAUTION Be sure to follow ESD precautions by grounding yourself to the cabinet
chassis using a wriststrap. (The cabinet chassis has wriststraps
permanently attached at both the front and rear.)
1. Using a #10 TORX head driver, remove the cover blank from the slot you want to use for
the HP-HSC I/O card.
The screws that secure the cover blanks are spring loaded. When removing the screws,
apply slight inward pressure to prevent the screw from separating from the spring.
When the screw no longer moves outward, it is detached from the cover plate.
2. Orient the HSC I/O card so that the connector at the back of the card faces the
connector on the HP-HSC I/O Bus Converter.
3. Using light pressure at the back of the HSC I/O card, press the card against the
bulkhead of the HP-HSC I/O Bus Converter. See Figure 3-4.
Figure 3-4 Attaching an HSC I/O Card to an HP-HSC I/O Bus Converter
3-14 Chapter 3