Table of Contents
Advertisement
Installation
Summary
On all other systems:
Verify that power modules are properly installed:
a. Slot P10 contains +5V 130A (650W) power module.
b. Slot P12 contains Miscellaneous Power Module (MPM).
c. Slot P14 contains +24V module.
d. Slots P6, P7, and P13 contain +5V 325W (65A) power modules.
e. Systems with more than 8 processors: Slot P1 contains +5V 130A (650W) power
module.
f. Verify that input power meets requirements.
g. Install power cord and plug for European/international locations. (Not necessary for
North America.)
6. Install/verify HP-PB I/O cards:
a. BC card (lower port) in double-high slot 14/15.
b. Console/LAN card in double-high slot 10/11.
c. T-Class only: MUX-16 card in slot 7.
d. 99x only: PBA-IB card in double-high slot 2/3.
e. HP-FL system disk. (Not supported on T600 Systems.)
i. HP-FL (PB-FL) card in double-high slot 12/13.
ii. SCSI card in slot 9.
f. SCSI or Fast/Wide SCSI system disk:
i. HP-FL (PB-FL) card in double-high slot 8/9. (Not supported on T600 Systems.)
ii. SCSI (single ended) card in slot 13.
iii. SCSI (Fast/Wide) card in slot 12/13.
g. Other cards should follow HP-PB guidelines; see Appendix B (Configuring the
HP-PB Cardcage):
i. Power guidelines (so HP-PB card cage is not overloaded).
ii. Performance guidelines. Some rules of thumb:
1. 99x: Install cards for disk drives in higher numbered (higher priority) slots,
but below LAN/console card.
2. T-Class: Install LAN cards in higher numbered (higher priority) slots, but
below LAN/console card.
7. Make/verify internal connections.
3-4
Chapter 3
Advertisement
Table of Contents
