Moving The Cabinet To The Site; Accessing The Lifting Nuts - HP 3000 99x Family Installation Manual

Unpacking and Inspection

Moving the Cabinet to the Site

Moving the Cabinet to the Site
Carefully roll the cabinet to the installation site.
If the cabinet is to be hoisted into position, you can access lifting nuts on the cabinet as
described below:

Accessing the Lifting Nuts

NOTE Only perform the following procedure if you need access to the lifting
nuts to attach a chain hoist.
The unit is equipped with 4 lifting nuts which are used for attaching eyebolts for a chain
hoist. The nuts are 3/8-inch, with 16 threads/inch. To access the lifting nuts (see Figure
2-5):
1. Open the front door of the system.
2. Remove the fan guard grill (just below the fan tray) by unfastening two M4 screws.
3. From the front of the system, remove the two M6 screws (one on either side) that fasten
the side walls to the frame. These two screws are just behind the fan guard grill.
4. Open the rear door and remove the two M6 screws (one on either side) that fasten the
side walls to the frame.
5. Remove the left and right side walls from the system. A side wall is removed by lifting
the bottom end outward, then lifting the wall upward.
6. The 4 lifting nuts (on the top of the frame) are now accessible.
2-10 Chapter 2